A cursor that freezes, jumps, or disappears is annoying, but it rarely means your computer is broken. Most mouse and touchpad problems come from a small set of causes: a flat battery, a loose receiver, a dirty sensor, a disabled touchpad, or a driver that needs a refresh.
Start by ruling out the obvious. For a wireless mouse, replace or recharge the battery and check that the power switch is on. For a wired mouse, unplug it and plug it back into a different port, and try it on another computer if you can. If it works elsewhere, the problem is with the first computer, not the mouse. Clean the sensor on the underside with a dry cloth, and test the mouse on a plain sheet of paper rather than a glossy or glass surface, which can confuse optical sensors.
Check the Touchpad Settings and Shortcuts
On a laptop, the touchpad can be turned off by accident, often by a function-key shortcut or a setting that disables it when a mouse is connected. Look for a touchpad toggle key, usually marked with a small touchpad symbol, and press it once. Then open your system settings and confirm the touchpad is enabled, with a sensible pointer speed and without a setting that turns it off while typing.
Wireless receivers are another common culprit, especially on crowded desks. Move the receiver to a port closer to the mouse, away from metal objects and other wireless dongles, and keep the mouse within a reasonable distance of the computer. If your mouse uses Bluetooth, remove it from the paired-device list and pair it again from scratch.
Update Drivers and Rule Out a Wider Problem
If the hardware checks out, look at software. Open your device manager or system settings, find the mouse or touchpad entry, and check for driver updates. If an update was installed just before the problem began, rolling the driver back can help. You can also test in a different user account or after a clean restart with no extra programs running, which shows whether background software is interfering. Similar port and device checks help when another USB device is not recognised either, so it is worth reading our guide to fixing a USB drive that is not recognised if several USB devices misbehave at once.
Finally, pay attention to whether the whole computer is struggling, not just the pointer. If clicks lag, windows freeze, and the cursor stalls together, the mouse may be a symptom rather than the cause. In that case, follow the steps in our guide to a computer that keeps freezing and restarting before buying a replacement. If the pointer alone is dead, the device is not detected anywhere, and a known-good mouse also fails on the same computer, it is time to get the port or the built-in touchpad checked by a repair shop rather than guessing further.